Power Supplies
-
Power Supplies for Command Access MLRK1-FAL17 MEL Kit
$140.00Command Access PS202 Power Supply. This Will Power TWO (2) MLRK1 MEL Kit.
PS202 - 110-120VAC input power supplies that deliver (2) amps @ 24VDC to (2) PTC fused outputs. (2) solid-state input triggers, protects system relays from shorts, grounds and surges. Its linear design makes it a perfect match for electric locks, motor driven exit devices, electric strikes, and mag locks.
DOWNLOADS
Learn More
PS202 Cut Sheet
PS202 Installation Manual -
Power Supplies for First Choice MEL & EL Panic Devies
$150.00Not Sure Which Power Supply you need?: Power Supply Selector
1 Amp SINGLE Output - ( PSMEL1500-1 )Power Supply for MEL Motorized Latch Retraction capable of operating one (1) 1amp-24VDC panic hardware device.
• In addition, an auxiliary power output shall provide power for accessory devices such as card
readers, key-pads, REX PIRs, electronic timers, relays, etc.
Single MEL Submittal
Single MEL Install Manual1 Amp DUAL Output - ( PSMEL2000 ) Power Supply for MEL Motorized Latch Retraction capable of operating up to two (2) 1amp-24VDC panic hardware devices simultaneously
• Each lock output shall have an adjustable relock delay timer
• It shall control a pair of doors simultaneously or independently two doors
• Relay for each output to trigger external relays, ADA push plate switches, etc.
• Delayed follower relays shall control automatic door operators for doors that are always locked
or for doors that are unlocked during the business day
• Two un-switched auxiliary voltage outputs shall provide/remove power to the lock outputs when activated
• A programmable FACP interface shall provide power/remove power to the lock outputs when activated
• Shall have LED status indicators monitor AC, FACP status & for lock output wiring supervision
• Intelligent logic shall provide protection against accidental shorting of lock outputs.
Dual MEL Submittal
Dual MEL Install Manual16 Amp SINGLE Output - ( PSEL1500 ) Power Supply for (solenoid) EL Electric Latch Retraction operates one (1) 16amp-24VDC panic hardware device.
• It is designed to handle the high current surge panic hardware locking devices demand.
• In addition, an auxiliary power output provides power for accessory devices such as card readers, key-pads, REX PIRs, electronic timers, relays, etc.
Single EL Submittal
Single EL Install Manual16 Amp DUAL Output - ( PSEL3000-2 )DUAL Power Supply for (solenoid) EL Electric Latch Retraction will operate up to two (2) 16amp-24VDC panic hardware devices simultaneously
• It is designed to handle the high current surge panic hardware locking devices demand
• Each lock output has an adjustable relock delay timer
• It will control a pair of doors simultaneously or independently control two individual doors
• It has a follower relay for each output to trigger external relays, ADA push plate switches, etc.
• Delayed follower relays control automatic door operators for doors that are always locked or for doors that are unlocked during the business day
• In addition, two un-switched auxiliary volt-age outputs are provided for powering card readers, keypads, REX PIRs, electronic timers, relays, etc.
• A programmable FACP interface will either provide power or remove power to the lock outputs when activated.
• LED status indicators are provided to monitor AC power, FACP status and for lock output wiring supervision.
• Intelligent logic provides protection against accidental shorting of lock outputs.
Dual EL Submittal
Dual EL Install ManualFree Shipping On Power Supply When Purchased Along With A First Choice Panic Bar. (Lower 48 States)
Learn More -
Von Duprin PS902 Power Supply
$200.00Base Power Supply (2A @ 12/24 VDC field selectable).
PS902 Works Von Duprin EL Lever Handles
PS902-2RS (900-2RS Board) Works Von Duprin QEL Panic Devices2A @ 12/24 VDC output, field selectable with jumper.
Low voltage DC, regulated and filtered output.
Class 2 Rated power limited output.
AC input and DC output monitoring circuit w/ LED indicators.
Universal 120-240 VAC input.
Learn More
DOWNLOADS
PS902 Data Sheet
Installation Instructions -
Von Duprin PS914-2RS Power Supply
$740.00Von Duprin PS914-2RS series power supply.
The only power supply for use with Von Duprin EL exit devices such as the EL99 & EL9927.
The regulated output power is field selectable for either 24VDC or 12VDC @ 4 amps.
Standard power input 120/240 VAC.
The PS914-2RS replaces the obsolete PS873-2 power supply.DOWNLOADS
Learn More
PS914 Data Sheet
Installation Instructions