Sweeps / Accessories / Misc

Wool Pile For DoorStops On Tubelite / Aroyan Doors

P1098A = 1/4" Wide X 5/16" Tall With Vinyl Fin

All Products Are Currently Only Available in Grey Color

Note: All Products Are Priced PER FOOT.  (Example: If You Add A Quantity Of 8 Into The Cart You Will Get 8 Feet)

Wool Pile Running Down The Centers Of Meeting Stiles On Tubelite / Aroyan Doors

P938 = Wool Pile For Tubelite Adjustable Astragal - 1/8" Wide X 1/2" Tall ( 2 Strips Per Astragal ) - TubeliteStandard

P13D = Wool Pile For Tubelite / Aroyan - 3/8" Wide X 7/16" Tall ( 1 Stripe Down Center ) - Aroyan Standard

P13A = Wool Pile For Tubelite / Aroyan - 3/8" Wide X 5/16" Tall ( 1 Stripe Down Center ) - Used When P13D Is Too Tight (Uncommon)

All Products Are Currently Only Available in Grey Color

Note: All Products Are Priced PER FOOT.  (Example: If You Add A Quantity Of 8 Into The Cart You Will Get 8 Feet)

Latch Lock Face Plate For Singles Or Pairs Of Doors, Comes With Screws.

Special Oversize Style Face Plates For Aroyan / Tubelite Doors Only

See 2nd Picture For Handing.

Adams Rite 4902-01 - Flat For Frame Side - Includes molded black plastic dust box and steel mounting plate
Adams Rite 4902-02 - radiused strike plate, for the nose of the opposite door when latching pairs. - Includes molded black plastic dust box and steel mounting plate

DOWNLOADS
Data Sheet
Installation Template

Door sweeps are surface applied to the face of a door.
They are commonly used on the exterior of out swing doors. 
Sweeps Screw Applied
Aluminum/Vinyl Sweep

P1275A = Sweep Length is 36"

P1276A = Sweep Length is 42"

P1277A = Sweep Length is 48"

Please call if you need a BRUSH insert instead.

DOWNLOADS
Sweep Cut Sheet

Door sweeps are surface applied to the interior face of a door.
They are commonly used on the interior of out swing doors. 
Sweeps Screw Applied
Aluminum/Vinyl Sweep

P1275 = Sweep Length is 36"

P1276 = Sweep Length is 42"

DOWNLOADS
Sweep Cut Sheet

This angle drops the closer by 3/4", lowering the closer just enough to clear the top of the closer knuckle if you have a soffit over the top of your frame. Reusing the previous bottom hole loctions on the header.

1" x 1" x 1/8" thick aluminum angle bracket pre-machined for standard closers that measure 9-1/16" CTC wide x 3/4" CTC tall.

Comes with two 12-24 x 1/2" screws to mount the angle to the underside of the header.

Available in both Clear and Dark Bronze Anodized finishes.

DOWNLOADS
Diagram Template

Example Closers To Fit This Bracket:

• Norton 1600 Series
• Dormakaba/Stanley QDC300 Series
• LCN 1250 Series
• Falcon SC61
• Hager 5300
• International 8051-TP