Sweeps / Accessories / Misc

Seals gaps up to 1” (25 mm)
Lowest profile, 1 9/16” (40 mm)
Minor installation adjustability, 1/16” (2 mm)
Includes self-drilling, 1” mounting screws with combo Phillips & Hex head
Screw Applied - Cut to length - Sold at 48" Long to fit any size door

Cut to size using common tools
Enhanced vertical adjustability for hassle-free installation
Easy install screw-on end caps
Interior or exterior installation

Current discontinued "OLD" Version inventory Includes: (seen in last image)
- 1 @ 36" Clear Anodized
- 1 @ 36" Dk. Bronze  Anodized
- 5 @ 48" Dk. Bronze Anodized

DOWNLOADS
Xcluder Sweep Submittal Sheet
Xcluder Install Instructions

Trine BZ-12 Audible Buzzer for 12vDC power
Trine BZ-24 Audible Buzzer for 24vDC power

DOWNLOADS
Buzzer Size

Door sweeps are surface applied to the face of a door.
They are commonly used on the exterior of out swing doors. 
Sweeps Screw Applied
Aluminum/Vinyl Sweep

P1275A = Sweep Length is 36"

P1276A = Sweep Length is 42"

P1277A = Sweep Length is 48"

Please call if you need a BRUSH insert instead.

DOWNLOADS
Sweep Cut Sheet

Door sweeps are surface applied to the interior face of a door.
They are commonly used on the interior of out swing doors. 
Sweeps Screw Applied
Aluminum/Vinyl Sweep

P1275 = Sweep Length is 36"

P1276 = Sweep Length is 42"

DOWNLOADS
Sweep Cut Sheet

Used with the SDC 45 Series electric Strikes to make an auditable buzzing noise.

Used with the SDC 45 Series electric Strikes.

The SDC BR64XL is a bridge rectifier that converts AC transformer output to DC. The unit is equipped with 6" wire leads.

Technical Specifications: Input: 12 or 24VAC Output: 12 or 24VDC 4 Amps Maximum Load

Schlage 679-05HM Concealed Door Position Switch

Door position switch is used to detect the open or closed status of an opening and then send this status to a control panel.

Designed for monitoring door positions, roof hatches, gates etc.

• For hollow metal doors and frames
• SPDT Magnetic Switch 
• 0.3 Amps @ 30 VDC.

DOWNLOADS
Cut Sheet
Installation Template

LCN 4110-18 PA Mounting Plate for LCN 4111 EDA Closer

DOWNLOADS
Installation Instructions